Sod Removal

     Using a square shovel, all vegetation must be removed from the ground allotted for an above ground pool installation. One could even rent a sod cutter for a few hours to cut all the vegetation in a few minutes. Some areas in the US require up to 6 inches of clear area all around the pool. Thus, the local codes must be checked.

     Site Leveling

     After sod removal, the next step is leveling the installation site. Uneven ground cannot be fixed after above ground pool installation and water addition. Moreover, an uneven surface will give the pool a lopsided appearance, which is why this step is a crucial one. Instead of filling the low spots, it’s advisable to dig out the high spots. Flat patio stones are to be installed at each upright location as per the instructions. These patio stones must be leveled to the ground as well as to each other. Tamp and level the ground with a minimum 2 inches of masonry sand or clean soft sand. The site drainage should also be taken into consideration.

     Pool Wall Assembly

     The next significant step is to level and round the walls of the swimming pool. While leveling the walls assembly, it is important to check and make sure it is perfectly square if the pool is oval or perfectly round if it is a circular shaped pool. This is to make sure that the pool liner fits properly and the pool posts don’t lean in or out in a conspicuous manner.

     Liner Installation

     While lining a pool, some wrinkling is prone to happen, though not in massive amounts. In order to avoid wrinkles, while overlapping the liners, one should remove the excess material as water is added. Smoothen the material out to the sides with beaded liners. Patience and diligent effort is required to achieve proper installation of swimming pool liner.

     Frame Assembly

     As per the manufacturer’s instruction manual, one could begin the frame assembling procedure. Uniform spacing between the track connections must be checked and if all the pieces are uniform in shape and dimension, then the final assembly of the pool will be smooth.

     Safety Signs and Warranty Information

     The safety signs supplied by the manufacturer need to be attached to the pool. The warranty and other instruction booklets must be stored away safely, as they will be required in the future.

     Excavated Ground Material

     Next comes the even dispersal of the excavated site material after installing above ground pool. The excavated material should be used to even out the area of the backyard and fill the low spots. One can be creative and come up with some swimming pool landscaping ideas.

     Local Code Awareness

     Before installing above ground pool, one should obtain the permit for above ground pool installation and display it prior to commencement of its construction. The pool must be listed according to the zonal rules and underground pipes and wires are to be avoided.

      Electrical System Requirements

     Proper wiring of the above ground pool pump must also be arranged for. A 120 volt power line running underground, as per the code requirements should be provided for from the main source power panel, which is wired directly to the pump. Additional outlets are also required near the pool.

     These above ground pool installation instructions are just a framework or guide to carry out above ground pool installation. The actual instructions are far more detailed and the process is also quite complex. It is appropriate to ask for professional assistance while constructing an above ground swimming pool.

     Get more information here.